The source code will be Open-Source and will be hosted on Google Code, you can get code for quad copter here:

http://code.google.com/p/picquadcontroller/source/browse/#svn/trunk

As usual I like to start with a video demo, it's basically me controlling the tilt of the quad using a RC controller:

This is a PID feedback algorithm and a "Simplified Kalman Filter" as  described in my other articles.

First of all there's a a RCGroups thread where I first introduced the project

http://www.rcgroups.com/forums/showthread.php?t=1235360

You'll find some specs there and I will put some material here  as well.

Here is Revision 0.1 of schematic (what I started with):

PicQuadControllerRev01.pdf

The major parts list is as follows:

MCU:  DSPIC33FJ128MC802  (http://www.microchip.com/wwwproducts/Devices.aspx?dDocName=en532302)

Sensors: 5DOF Acc_Gyro ( http://gadgetgangster.com/213 )  + 1Dof Pololu LIST300AL-BREAKOUT (http://www.pololu.com/catalog/product/765).

Motor Drivers:  Power N-Channel Mosfets (Many choices -Low Rds(on) and rated for the current , I used  IRLR8743 ). Schottky diodes to protect against back-EMF ( I used SS2H10-E3/52T )

Frame , motors propellers: I picked a ready platform that was on sale Dragandfly IV Frame these are actually brushed motors same ones as used in Esky helicopters.

I did some tests on the lift force potential of this frame+motors+props, and was surprise to find out it performed better than some entry-level brushless motors. The lift force of this platform is up to 2.25 lbs.  The results of lift-force experiments are compiled in this spreadheet: MotorLiftPower.pdf.

How I measured the lift force ?  I didn't have any fancy equipment so I simply fixed the quad in a vise and weighted  it it at different throttle levels – the difference in weight gave me the lift power.

For testing just one motor, I used a string attached to the weight:

I built a test rig out of wood for testing the tilt balancing algorithm as you see in the video.

Here are some close-ups of the motor drivers. You'll  see the Mosfets and the Schottky diodes, also note the extra solder added to support the high currents that will flow through those traces ( up to 5A per motor !).

Finally here is a view on the top of the board ( notice the PIC , the switching regulator  ,  Acc_Gyro 5DOF IMU and single axes Gyro breakout , from top-left to bottom right).

This is it for now hope to bring you more interesting stuff on this and other projects if time allows  !

//starlino//